How to 12 volt fan mod a xbox 360
This is 100% my video. Don't believe me? Ask me to prove it and I will!
Supplies:
Torx T-10 screwdriver
30awg or cat-5 ethernet wire
wire cutters
wire strippers
wire connecters
common sense
Steps:
Step 1:
Acquire a xbox 360 with a fan!
Step 2:
Then take apart the xbox 360 with a TORX T-10 Screwdriver!
Step 3:
Take out the DVD drive and the fan and you will also need to take out the SATA cable and other cable to the DVD drive!
Step 4:
Get you Fan and find the brown and red wires (don't touch the blue and black they are just grounds) and snip the red and brown wires about a inch above the plastic connector and strip both ends of the wires!
Step 5:
Take the two wires that you just cut(brown and red wires) and twist them together and put a wire connector or solder them together!
Step 6:
Now take your DVD drives sata cable ( the wire with the white connectors) and cut the bottom right wire and strip it (Look at the picture) and then take the two ends and twist them together just like you did with the fan and add a wire connector or solder them together!
Step 7:
Then get a peice of 30awg wire or cat-5 ethernet wire and strip the ends and put one end in the wire connectors on the fan and the othe end of the wire into the wire connector on the sata cable!




Reply With Quote





















